The Lumenier MICRO LUX V2 F4 Flight Controller with OSD brings incredible power and performance to the micro brushless world. It uses a powerful F4 processor along with top of the line hardware. Now you can get all the performance from an F4 based flight controller in a micro size! The V2 now includes an on-board Betaflight OSD. Using an On Screen Display has never been simpler, just drag and drop in the Betaflight Configurator. This flight controller uses 20x20mm mounting holes and a low profile design allowing for smaller airframe designs than ever before. The MICRO LUX V2 comes with BetaFlight pre-installed.
The MICRO LUX supports both SBUS and PPM inputs as well as DSM/DSMX receivers with both 5v and 3.3v support.
Software/Hardware Features
- 2-4S Direct Lipo input support (5-16v)
- On-board BetaFlight OSD
- On-board 5v/2A and 3.3v/0.2A regulators
- SBUS and PPM support
- RGB LED dedicated pad, Current Sensor pad and Buzzer Pad
- VBAT Monitoring support
- 3x UART Ports
- Betaflight support (Supports new DSHOT protocol)
- BLHeli passthrough flashing supported by hardware
Specifications
- STM32F405 (2MB flash) 32-bit processor
- MPU6000 Gyro/Accelerometer
- High quality 1.6mm PCB
- Micro USB connector for programming
- Dimensions: 27x27x6mm (includes USB in height)
- Mounting Holes: 20mm square to center of holes
- Weight: 4g
Includes
- 1x Lumenier MICRO Lux V2 F4 Flight Controller w/ OSD
- 1x Set of plastic 5mm and 3mm standoffs + screws / nuts
Optional Recommendations
We suggest the following gear to complete your micro brushless build. (Not included)
Downloads
- Download Betaflight Configurator - Latest Betaflight Firmware (Load the "VGOODDHF4" target, LUXF4OSD in BF 3.2 and above)
Videos
Coming soon..
Lumenier™ and LUX™ are registered trademarks of Lumenier.