
The BeecoreX FR V1.0 is the ultimate 5-in-1 flight controller for a Brushed Tinywhoop and includes an F4 FC, VTX, ESC, frsky receiver, and betaflight OSD. This AIO FC makes building a brushed tiny whoop a no-brainer! Just add your FPV camera, brushed motors, frame, and propellers... then plug and play - no soldering required.
Features
- 5-in-1 F4 FC, VTX, ESC, frsky receiver, and betaflight OSD
- No soldering required
Specifications
- R1(RX1) Pad is used for IBUS/DSM2/DSMX signal input
- IR1(IRX1) Pad is used for SBUS signal input (Already inverted)
- R1 and IR1 Cannot be used simultaneously
- Mounting Pattern: 25.5x25.5mm
Flight Controller
- (Frsky SPI RX version) Betaflight Firmware target: CrazybeeF4FR
- MCU:STM32F411CEU6 (100MHZ, 512K FLASH)
- Sensor: MPU-6000(SPI connection)
- Board size: 28.5 * 28.5MM
- Power supply: 1S battery input (DC 2.9V-4.35V)
- Built-in 5A(each) Brushed 4in1 ESC
- Built-in Betaflight OSD(SPI Control)
- Built-in 5.8G VTX 25mw~100mw switchable
- Built-in SPI Frsky receiver(compatible with Frsky_D/ Frsky_X/ S-FHSS/ Redpine protocol)
- Built-in 5V 1A BEC
- Built-in voltage detection
Onboard Frsky SPI - Receiver Version
- SPI BUS receiver Frsky version
- Compatible with Frsky D8/D16 ( D8 is recommended), S-FHSS, Redpine protocol
- Channels: 8ch
- Failsafe support
- No ground interference ( Transmitter and receiver 1 m from the ground): 100m~200m
- RSSI compatible
Onboard 5.8g VTX
- Output power: 25mw~100mw switchable
- Frequency: 40CH
- Input voltage: 3.3V 5.5V
- Current consumption: 300mA(type)
- Frequency: 5.8GHz 5bands 40 channels
- With Race band
- Smart audio ready
- VTX POWER=1 (25mw)
- VTX POWER=2(50mw)
- VTX POWER=3(100mw)
- Recommend to use 50mw
- Recommend Runcam Nano3 camera, plug and play
Includes
- 1x Happymodel BeecoreX Fr V1.0 AIO F4 5-in-1 Brushed Flight Controller /w VTX+RX
- 2x Connecting Wires
- 4x Damping Balls
- 5x Screws