Tiny, light and durable A01 VTX, comes with a port to connect with FC and mounting holes to fix on the canopy, convenient for installation. Compatible with Beta75X FPV (3S), Beta75X HD (3S), Beta85X FPV (4S), Beta85X 4K and HX100.
Features
Switchable power includes 0mW, 25mW and 200mW.
SmartAudio function is included in this VTX. The flight controller can communicate with the video transmitter using the audio line in. It allows the flight controller to know what frequency the VTX is using, and to change it.
PitMode is supported on this VTX.
Dipole whip high sensitivity antenna. It is mounted to the VTX board durable.
Blue LED
Red LED
Power Status
Flash Solid
Off
25mW
Flash Solid
Flash Solid
200mW
Off
Flash Solid
PitMode
Specifications
Output power: 0mW, 25mW and 200mW (Adjustable)
Supply Voltage: 5V. NOT support connect to the 1S battery directly
Weight: 2.0g
Frequency: 5.8GHz 6 bands 48 channels, with Raceband: 5362~5945MHz
Recommended Parts
Adapt Canopy: EOS2 Canopy, 4K Canopy
Adapt Cable: Power Whoop Connector Cable Set
Adapt Drone: Beta75X FPV (3S), Beta75X HD (3S), Beta85X FPV (4S), Beta85X 4K Whoop Drone, HX100.
How to Change Frequency, Channel & Power
Only support frequency and power change through the SmartAudio interface.
Method 1: Use the OSD menu.
Enter the OSD menu by radio transmitter sticks ( Pitch Stick UP and Yaw Stick Left). Then FEATURES -> VTX SA to change the frequency and power.
Method 2: Use the Betaflight GUI command.
We could also use the Betaflight CLI commands to change the frequency and power of the VTX.
For example, set the frequency to 5865 and power to 200mW ( 1 for 25mW / 2 for 200mW);
set vtx_band=1set vtx_channel=1set vtx_freq=5865set vtx_power = 2save
How to Use the PitMode
PitMode allows racers to power up their video transmitters during race events without interfering with other racers and still having the ability to change VTX settings or do some testing. The range is limited to 2-3m and transmission happens on the selected frequency.
The PitMode is active when only the red LED flash solid.
How to active the PitMode: Enter the OSD menu by radio transmitter sticks. FEATURES -> VTX SA -> CONFIG -> PIT FMODE. Then select the PIR status.
How to exit the PitMode
As the same above, select the OP MODEL to FREE to close the PitMode. Then the VTX will recover to the 25mW power status.
Transmission Frequency Table
This A01 VTX could support 3 frequency table according to your local law. The tables below are for all the frequency is valid.
USA frequency table below. The frequency in the red item is invalid.
Europe's frequency table below. The frequency in the red item is invalid.
Includes
1 x BETAFPV A01 5.8GHz VTX
1 x 5-Pin FC Cable